「工程科技与教育学刊」著作权授权书.PDFVIP

「工程科技與教育學刊 」著作權授權書 文稿： 乙篇。如本文被工程科技及教育學刊接受刊登，著作權即為國立高雄應用科技大學工學 院所有，著作人仍保有未來集結出版、教學及網站等個人使用之權利，如： 一、該著作之全部或部分著作人教學用之重製權。 二、出版後，該著作之全部或部分用於著作人之書中或論文集中之使用權。 三、本著作用於著作人受僱機關內部分送之重製使用權。 四、本著作及其所含資料之公開口述權。 五、本著作同意 教學研究人員重製或再利用 。 著作人需確保 本文為原始資料，未曾也不考慮於其他國內外雜誌上發表 ，且著作未含有 誹謗或不法之內容，且未侵害他人智慧財產權。且若因審稿、校稿因素導致著作名稱變動， 著作人同意視為相同著作，不影響本讓與書之效力。 所有作者均對本文之完成提供智慧上實際貢獻，願對本文之內容承擔公共責任，若所有 作者同意上述，請委任一代表作者在空白處簽名。 作者簽名： 年 月 日 附件六 Notes for Contributors The Journal of Engineering Technology and Education 1. Journal of Industrial Technology and Education publishes research paper, technical communication on all aspects of engineering technology, administration, engineering education. 2. The journal operates an anonymous double-blinded peer review process. Each manuscript will be reviewed by at least 2 referees. 3. Submission of a manuscript implies: that the work described has not been published before; that it is not under consideration for publication anywhere else; that its publication has been approved by all co-authors. The publisher will not be held legally responsible should there be any claims for compensation. 4. The manuscript should be divided into the following sections: (1) Abstract, (2) Introduction, (3) Materials and Methods, (4) Results and Discussion, (5) Conclusions, (6) Acknowledgements, (7) References. The format of manuscript can be downloaded from .tw/edu/engh/. 5. Figures and photographs should be in black and white, numbered, titled and have descriptive captions. SEM and TEM images and other micrographs pictures should be marked with magnification scale. If any magnification is used in the photographs, indic