音频频率数字扫频仪.docVIP

C2000参赛项目报告（命题组） 题 目： 基于TMS320F2808的音频频率数字扫频仪 学 校： 云南大学 指导教师： 基于TMS320F2808的音频频率数字扫频仪 摘 要：本数字扫频仪采用TMS320F2808DSP芯片作为核心器件，实现了命题中的全部技术指标。本设计在不使用DAC与DDS芯片的情况下，根据DDS芯片的原理利用F2808芯片在软件上实现了DDS的功能，产生了步进小于1.5Hz的扫频信号。带阻网络采用Sallen-Key有源滤波器结构，使陷波中心频率的衰减大于10dB(以10KHz为基准)。为了充分发挥F2808的软件资源，本设计未使用硬件峰值检波电路而是直接对带阻网络输出信号进行高速采样，实现了对幅频特性的精确测量。在显示模块中，按照约定的协议令F2808的SCI和PC进行通信，在PC端利用Labview软件开发了友好的显示界面，可方便对被测带阻网络的幅频特性信息进行处理、显示、存储和波形的打印输出。系统测试结果表明本设计方案是可行的、精确的。此外，本论文详述了均衡算法，计算出了算法中的关键参数并对算法的实时运算量进行了分析。 关键词：?音频频率 数字扫频仪 DSP 均衡算法 实时处理 Digital tester for audio frequency response characteristic based on TMS320F2808 Huangjingchang，Mushujuan，zhaojinli (School of Information Science and Engineering,Yunnan University) Abstract： A simple digital frequency response characteristic tester is developed with TMS320F2808 DSP chip in our design, we have realized all of technical specifications. Without using DAC and DDS chip, we have achieved the function of DDS by means of F2808’s software resources. According to the principle of DDS, we get the audio frequency signal whose increment is less than 1.5Hz. Sallen-key structure is adopted as band-stop network, it makes frequency response characteristic attenuates greater than 10d- B(with 10KHZ as the standard) at notch center frequency. In order to reduce cost and not to use hardware peak amplitude detector circuit, we sample the output signal of bandstop structure in a high speed sampling rate, and finally get the amplitude-frequency characteristics accurately. In display module, F2808 communicates with PC in centain protocol , and at the PC-side Labview is used to develop a friendly interface, which is convenient to process and save data, display graph, as well as print out amplitude-frequency graph of band-stop network. System’s test shows that our design is feasible and accurate. Besides, the paper details equalization-algorithm, calculates