思科ASA防火墙VPDN拨号配置命令整理.docxVIP

思科ASA防火墙VPDN拨号配置命令整理 This article is Adreaman according to cisco ASA8.2 L2TP and PPPoE function is introduced in the configuration document manual sorting out, introduce the cisco ASA (software version 8. 2) in the firewall PPPoE/L2TP both the characteristic of VPDN configuration steps? Can be compared to the cisco PIX firewall VPDN dial-up configuration command, which was introduced earlier in this blog. Cisco ASA firewall support for PPPoE die nt dialing, support for L2TP server acceptance, and support only L2TP over IPsec approach, and do not support pure L2TP? The ASA cisco document does not introduce PPTP, and the part of the PPTP is removed from the comma nd line, and the support for PPTP should be removed? Note: this article is not a personal record of the real configuration steps, but the cisco configuration manual analysis and comments, to help us understand the configuration of a whole train of thought? One, PPPoE configuration defines the PPPoE service VPDN group The VPDN group group name request dialout pppoe Specify the protocol used for PPP authentication The VPDN group groupname PPP authentication {chap | mschap pap} mschap supports only vl. 1.3 binds the PPPoE client user name to the VPDN group The VPDN group group_name localname username Specify a password for the user VPDN username password password [store - local] The 1.5 interface enables PPPoE functionality IP address pppoe [setroute] in the interface view: this command has been moved to the interface view relative to PIX6? 3, so you don，t need to specify the interface name as a parameter? Specify the VPDN group for the interface Under the interface view, pppoe client VPDN group grpname note: PIX6? 3 does not have this command, and if you do not specify the VPDN group, you will randomly use a VPDN group. 1. 1. 7 starts PPPoE, but the user specifies the IP address The interface view below the IP address ipaddress mask pppoe is specified by the user for the address and mask 1.8 show the order? Th