碟式曳引机配套方案2.ppt

——The new development of CYLON controller from RS in shanghai Overview of the system Typical structure * CYLON RS System installation Control cabinet installation * Ultra-thin control cabinet When the general embedded control cabinet inapplicable, you can choose ultra-thin control cabinet of our company which installed in the shaft; The ultra-thin control panel size: length * width * height (unit: mm) 340 * 130 * 1850; System installation Small top floor inspection box * When the ultra-thin control cabinet is used, small top floor inspection box needs to be installed; By using the small top floor inspection box you can get the information of leveling, safety loop and so on, and get the system debug, low speed moving, emergency stop etc. Top hall call top hall inspection control board Handhold operator System installation Encoder installation * Install the original tachogenerator friction wheel on the encoder connecting shaft; Encoder connecting shaft installed in the flange by two bearing; Sin-cos encoder Flange RS System installation * Installed the encoder in the flange, and encoder is closely connected with connection shaft through screw; Install the flange to the original position of tachogenerator, make the friction wheel in contact modestly with the outer tractive sheave. Sin-cos encoder Flange RS Encoder installation System installation Photoelectric switch installation * Two photoelectric switches installed respectively on the two short feet of bracket ; Adjust the two short feet to vertical the traction wheel radial direction; Photoelectric switch B Photoelectric switch A Photoelectric switch bracket RS System installation * Lead the lines of photoelectric switches to the external fixation to lead fixed hole; Photoelectric switch B Photoelectric switch A Photoelectric switch bracket RS Photoelectric switch installation System installation Photoelectric switch installation * Install photoelectric switches bracket on the brake installed slo