PV 6723_EN-铝点焊技术标准.pdf

Group standard PV 6723 Issue 2015-08 Class. No.: 04844 Descriptors: welding, spot welding, resistance spot welding, aluminum material Resistance Spot Welding on Aluminum Materials Previous issues PV 6723: 2011-04, 2011-05, 2013-04 Changes The following changes have been made to PV 6723: 2013-04: – Standard fundamentally revised 1 Scope This Test Specification (PV) applies to spot-welded joints of parts from 1.0 to 3.5 mm thick made of aluminum materials that are suitable for spot welding. If the wall thicknesses are not the same, this standard applies up to a wall thickness ratio of 1:2. For higher ratios and sheet metal thicknesses, a separate agreement must be reached between Design Engineering, Planning, and Production. This standard is used during sample inspections, acceptance tests, and production monitoring tests and provides information for defining finishing measures. Materials: aluminum materials Wrought alloys: 5xxx alloys: AlMg3.5Mn-IK (type: 5018) as per Porsche Technical Supply Specification PTL 202, AlMg4.5Mn0.4 (type: 5182) as per Technical Supply Specification TL 090, AlMg3.5Mn (type: 5042) as per DIN EN 573-3, AlMg5 (type: 5019) as per DIN EN 573-3 6xxx alloys: as per TL 089, TL 091, TL 094 A/B/C, TL 114 7xxx alloys: AA7021 Extruded alloy: as per TL 116 Die-cast alloy: as per TL 117 A/B/C, TL 119 For die-cast alloys, Planning, Production, Development, and Quality Assurance must be consulted. Always use the latest version of this standard. Page 1 of 20 This electronically generated standard is authentic and valid without signature. The English translation is believed to be accurate. In case of discrepancies, the German ver