【西门子】LDS 6 Service Instruction – H2O@NH3 Calibration Check 产品信息.pdf

LDS 6 Service Instruction A5 Edition 02/2019 Maintenance check for TÜV/MCERTS approved LDS 6 instruments. (Zero and reference point check H2O) 2 Kontrollen im Wartungsintervall für TÜV/MCERTS zugelassene LDS 6. (Null- und Bezugspunktkontrolle H2O) 6 Unrestricted © SIEMENS AG 2019. All rights reserved Maintenance check for TÜV/MCERTS approved LDS 6 instruments (Zero and reference check H2O) LDS 6 Service Instruction A5 1 LDS 6 Service Instruction Maintenance check for TÜV/MCERTS approved LDS 6 instruments. (Zero and reference point check H2O) Minimum Skill Level Approved Service Staff Calibration verification kit Tools A5E00823339014 or A5E00823339015 Spare Parts None About this document The procedure for following the TÜV certificate includes three main issues: 1. The hardware must not be altered from the original hardware delivered with the certificate. 2. Maintenance checks must be carried out regularly. 3. Annual Surveillance Tests (AST) must be carried out by an accredited measurement institute (e.g. according Bundesimmisionsschutz-Gesetz BImSchG §§ 26, 28) This document covers the maintenance checks according to point 2 above. For instructions on functional tests according to 3 above, please see separate service instruction. Introduction For LDS 6 ammonia/water analyzers a calibration check of the zero and reference point of the water concentration can be performed using the RC 3009 verification kit. This kit contains one 2-meter hybrid cable, one sensor board and detector and two black boxes to which the single mode fiber and the detector can be connected. One of the