钣金件和注塑件的结构设计结晶.pptVIP

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * 一平面和折弯面之间的转折最好有狭孔,或者将开孔边退到折弯之后.否则会产生毛边.而狭孔的宽度最好大于 等于肉厚的1.5倍.还有制图的时候 别忘了或偷懒而没标示R角.直角或 锐角的模具公,母模容易崩裂.日后的 停线,修模都是额外的损失. Mechanical Sheet Metal Design Guide Line *Optimize designs for sheet metal parts producibility 摘自—Mitac DESIGN FOR EXCELLENCE CHECKLIST 1.Minimize the number of steps for sheet metal stamping. 2. Select standard commercial, off the shelf drill rod, punch, tools related to standard hole, slot, sheet metal thickness, bending radii. 3. Design parts so that secondary burr removal operation is not required. (Some surfaces can have burrs others cannot.) 4. Drawings to indicate surfaces on which burrs are permissible. 5.If the part function requires a specific grain direction then this should be indicated on the drawings. Mechanical Sheet Metal Design Guide Line *Optimize designs for sheet metal parts producibility 摘自—Mitac DESIGN FOR EXCELLENCE CHECKLIST 6.Unless specified the tolerances shown on the hole diameters or contours are considered to apply to the punch side only. 7. Corner radii should be a of 1/2 the material thickness. 8. Minimum feature section should not be less than 1.5 to 2 times material thickness. 9. Hole diameters to be large enough to be punched. Punching being preferable to drilling. (Cost) Mechanical Sheet Metal Design Guide Line *Optimize designs for sheet metal parts producibility 摘自—Mitac DESIGN FOR EXCELLENCE CHECKLIST 10.Sharp corners to be avoided when designing openings. 11.The depth of draw to be kept shallow to minimize the number o die operations. 12.Use embossed or gusset forms to provide rigidity and maintain accuracy of angle of the bend. 13. two or more hols are used in mating parts it is necessary t