tl211-2014塑料外饰件涂层要求en暂不发.pdf

Group standard TL 211 Issue 2014-07 Class. No.: 50243 Descriptors: paint, paintwork, exterior plastic part, bumper, wheel trim, rear spoiler, tailgate, fender Paint Coatings on Exterior Plastic Parts Requirements Previous issues TL 211: 1974-11, 1983-10, 1989-07, 1992-08, 1992-09, 1995-03, 1995-10, 1998-06, 2003-02, 2003-03, 2009-09, 2009-10 Changes The following changes have been made to TL 211: 2009-10: – Section 3.1 General requirements, Two-component compositions paragraph revised – Section 4.1 General information changed – Section 5 Required properties: Table 2 changed – Section 6 Supplier requirements, production monitoring revised – Section 7 Applicable documents updated 1 Scope This Technical Supply Specification (TL) defines the requirements for primer coat, single, and mul‐ ti-layer paint coatings as per color combination table or special combination chart on plastic parts (hang-on parts, e.g. bumper, wheel trim, rear spoiler, trunk lid, tailgate, fender, etc.). 2 Description Paintwork as per TL 211 Always use the latest version of this standard. Page 1 of 10 This electronically generated standard is authentic and valid without signature. The English translation is believed to be accurate. In case of discrepancies, the German version is alone authoritative and controlling. Technical responsibility The Standards department GQL-P/1 Angela Kern Tel.: +49 5361 9 28507 GQL-P/1 Dr. Claudia Kühlmeyer-Freise Tel.: +49 5361 9 26163 EKDV/4 Gabriela Boch