e1408-91中文版-标准试验方法：门板和门系统传声损失的实验室测量方法.docVIP

E1408 PAGE 1034 Designation: E 1408 - 91 (Reapproved 1995)ε1编号：E 1408 – 91（1995年重新批准）ε1 An American National Standard一个美国国家标准 PAGE 1026 Standard Test Method forLaboratory Measurement of the Sound Transmission Loss of Door Panels and Door Systems This test method is under the jurisdiction of ASTM Committee E-33 on Environmental Acoustics and is the direct responsibility of Subcommittee E33.O3 on Sound Transmission..本规范由ASTM委员会E-33环境声学委员会管辖，并由E33.O3声音传播分委会直接负责。Current edition approved May 8, 1991. Published July 1991.现行版本于1991年5月8日批准，并于1991年7月出版。标准试验 This test method is under the jurisdiction of ASTM Committee E-33 on Environmental Acoustics and is the direct responsibility of Subcommittee E33.O3 on Sound Transmission..本规范由ASTM委员会E-33环境声学委员会管辖，并由E33.O3声音传播分委会直接负责。Current edition approved May 8, 1991. Published July 1991.现行版本于1991年5月8日批准，并于1991年7月出版。 This standard is issued under the fixed designation E 1408; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号E1408刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 ε1Note—Keywords were added editorially in November 1995.ε1注——关键词于1995年11月添加。 1. Scope 适用范围 This test method describes the laboratory measurement of the sound transmission loss for door panels and door systems. It also includes the measurement of the force required to close and latch, as well as to unlatch the door under test. An appendix presents methods to determine the respective contribution of the door components and seals to the sound transmission loss of a door system.本试验方法描述了门板和门系统声传声损失的实验室测量方法，也涵盖了受测门关闭、上锁、开锁所需力的测量。附录分别介绍了确定门部件和密封件对门系统传声损失的影响的方法。 This standard does not purport to address all of the safety concerns, if any, associated with its use. I