c1388-97中文版-实验室制作的砌块棱柱的抗压强度的标准试验方法.docVIP

C 1388 PAGE 931 Designation: C 1388 – 97编号: C 1388 - 97 PAGE 925 Standard Test Method forCompressive Strength of Laboratory Constructed MasonryPrisms This test method is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C 15.04 on Research.该试验方法归ASTM负责成品砌块的C-15委员会管辖，并由负责研究的C15.04小组委员会直接负责。 This test method is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C 15.04 on Research.该试验方法归ASTM负责成品砌块的C-15委员会管辖，并由负责研究的C15.04小组委员会直接负责。Current edition approved Jan. 10, 1997. Published May 1997. Originally published as E 447 - 72. Redesignated C 1388 - 97 in 1997. Last previous edition E 447 - 92b.现行版本于1997年1月10日批准，并于1997年5月出版。最初版本编号为E447-72，1997年修订为C1388-97。 This standard is issued under the fixed designation C 1388; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C1388刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense. Consult the DoD Index of Specifications and Standards for the specific year of issue which has been adopted by the Department of Defense.该标准已经批准被美国国防部机构使用。已被美国国防部采用的该标准出版的具体年份可以查看美国国防部技术和标准索引。 1. Scope 适用范围 1.1 This test method covers compression tests of masonry prisms for determining comparative data on the compressive strength of masonry built in the laboratory with either different masonry units or mortar types, or both.本试验方法涉及用于测定关于砌体结构抗压强度的比较性数据的砌块棱柱的抗压试验。砌体结构在实验室内建造，建造材料为不同的砌块或者不同的灰浆类型或者为不同的砌块和灰浆类型。 Note 1—This test method is not intended for use in establishing the compressive strength of a particular set of materials by