c410-60中文版-工业用地面砖的标准规范.docVIP

C 410 PAGE 230 Designation: C 410 - 60 (Reapproved 1997)编号：C 410 – 60（1997年重新审批） PAGE 229 Standard Specification for Industrial Floor Brick This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.09 on Chemical-Resistant Units.本规范由ASTM委员会C-15制造砌块委员会管辖，并由C15.09抗化学腐蚀砌块分委会直接负责。Current edition approved Sept 19, 1960. Published November 1960. Originally published as C 410 - 57 T. Last previous edition C 410 - 57 T.现行版本于1960年9月19日批准，并于1960年11月出版。最初版本编号为C410-57T，上一版本编号为C410-57T。 工业用地面砖的标准规范1 This standard is issued under the fixed designation C 410; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 410刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This specification covers brick made from clay or shale or mixtures thereof and are suitable for surfacing industrial floors. Ceramic shapes known as quarry tile are not covered by this specification. Four types of industrial floor brick are covered (Note):本规范涉及由粘土或页岩或其中的混合物制造的并适用于工业地面的砖。陶瓷砖称为铺地砖，本规范不涉及铺地砖。本规范包含四类工业用地面砖（注）： Type T—For use where a high degree of resistance to thermal and mechanical shock is required but low absorption is not required.T类——在需要高度抗热和抗机械冲击但不需要低吸收率的地方使用。 Type H—For use where resistance to chemicals and thermal shock are service factors but low absorption is not required.H类——在抗化学腐蚀性和热冲击是工作系数但不需要低吸收率的地方使用。 Type M— For use where low absorption is required. Brick of this type are normally characterized by limited mechanical (impact) shock resistance but are often highly resistant to abrasion.M类——在需要低吸收率的地方使用。此类砖通常以抗有限机械（撞击）冲击但常常高度抗磨损为特征。 Type L—For use where minimal absorption and a high deg