e1222-90中文版-实验室测量管绝缘系统插入损耗的标准试验方法.docVIP

E 1222 PAGE 998 Designation: E 1222 - 90 (Reapproved 1996) ε1 An American National Standard 编号：E 1222-90（1996年重新批准） 美国国家标准 PAGE 988 Standard Test Method for Laboratory Measurement of the Insertion Loss of Pipe Lagging Systems This test method is under the jurisdiction of ASTM Committee E-33 on Environmental Acoustics and is the direct responsibility of Subcommittee E33.O8 on Mechanical and Electrical System Noise. Current edition approved June 29, 1990. Published August 1990. 本试验方法由ASTM委员会E-33环境声学管辖，并由E33.08机械和电子系统噪声分委会直接负责。 现行版本于1990年6月29日批准，并于1990年8月出版。 实验室测量管绝缘系统插入损耗的标准试验方法 This standard is issued under the fixed designation E 1222; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval. 本标准以固定编号E 1222刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 ε1 Note—Keywords were added editorially in June 1996. 注——1996年6月编辑增加了关键词。 1. Scope 适用范围 1.1 This test method covers the measurement of the insertion loss of pipe lagging systems under laboratory conditions. 本试验方法涵盖了在实验室条件下对管绝缘系统的插入损耗进行的测量。 1.2 A procedure for accrediting a laboratory for purposes of this test method is given in Annex Al. 有关授权某一实验室对此试验方法进行测定的程序，请见附件A1。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish approspriate safety and health practices and determine the applicability of regulatory limitations prior to use.本标准并未对与标准使用相关的所有安全事项（如有）做出规定。本标准使用者有责任确立适用的安全和健康规范并在使用前评估其是否符合有关条例。 2. Referenced Documents 参考文件 2.1 ASTM Standards: ASTM标准： C423 Test Method for Sound Absorption and Sound Absorption Coefficients by the Reverberation Room Method Annual Book of