c118-95中文版-灌溉或排水用混凝土管道的标准规范.docVIP

C 118 PAGE 86 Designation: C 118–95编号：C 118–95 PAGE 79 Standard Specification forConcrete Pipe for Irrigation or Drainage1灌溉或排水用混凝土管道的标准规范 This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C13.01 on Nonreinforced Concrete Sewer, Drain, and Irrigation Pipe. 本规范受ASTM委员会C-13混凝土管道委员会管辖，并且由C13.01无钢筋混凝土污水管、排水管和灌溉管道分委会直接负责。Current edition approved Oct. 10, 1995. Published November 1995. Originally published as C 118 - 35 T. Last previous edition C 118 - 94.现行版本于1995年10月10日批准，并于1995年11月出版。最初版本编号为C118-35T，上一版本编号为C118-94。 2 Annual Book of ASTM Standards, Vol 04.02.ASTM标准年鉴第04.02卷。 3 Annual Book of ASTM Standards, Vol 04.01.ASTM标准年鉴第04.01卷。 4 Annual Book of ASTM Standards, Vol 04.05.ASTM标准年鉴第04.05卷。 This standard is issued under the fixed designation C 118; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C118刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This specification covers nonreinforced concrete pipe to be used for the conveyance of irrigation water with working pressures, including hydraulic transients, as shown in Table 1 and for use in drainage.本规范包含用工作压力运输灌溉水的无钢筋混凝土管道，包括表1所示的排水用液压瞬变流。 1.2 A complete SI companion to Specification C 118 has been developed—C 118M; therefore, no SI equivalents are presented in this specification.已制定规程C118的一个完整国际单位制指南-C 118 M；因此，本规范不会出现 Note—This specification is for manufacturing and purchase only and does not include requirements for bedding, backfill, installation, or field repairs. The owner is cautioned that he must correlate field conditions with the characteristics of the pipe specified and provide inspection during in