大迈X7各节点故障码：TPMS故障码.pdfVIP

20 / 72 Note: It is the responsibility of supplier to set the DTC related TPMS specific function according to ISO15031-6. The self-defined DTC of TPMS should be in the range from B180000 to B18FFFF. 4.2.11.1 Internal Fault DTC (Display) B100004 DTC (Hex) 900004 Malfunction Internal Fault (Coupled to special status dataIdentifier BMP-8- 1001) Test Frequency Once at initialisation Detection RAM, ROM, EEPROM shall be checked once at power up. A/D Converters and Charge Pump once every 1s. Decision The fault shall be stored in non volatile RAM when the fault has been present once at power up or for the A/D Converters and Charge Pump as stated in section “Fault Decision”. Faults-Recover - MCU voltage value is in normal range and so on Condition Exception No exception Action Taken Setting of the corresponding bit in BMP-8-1001 and statusOfDTC Possible Fault - MCU is destroyed by high voltage or high current. Causes Corrective - Keep normal range voltage for mcu and so on Action To Clear Clear Diagnostic Information or Automatic Fault Recovery 4.2.11.2 ECU Software Fail DTC (Display) B180004 DTC (Hex) 980004 Malfunction Software Fail Test Frequency Once at initialisation Detection TPMS warning thresholds not programmed to BATC requirement Decision The fault shall be stored in non volatile RAM Faults-Recover - TPMS warning thresholds is programmed in EEPROM Condition Exception -None Action Taken Setting of the corresponding bit in statusOfDTC Possible Fault Vehicle should not leave EOL with DTC set Causes Corrective - Program TPMS warning threshold