CCM单相boost功率因数校正系统的分析与研究.docVIP

PAGE I 摘要 本文设计了一种高功率因数、低电磁干扰的单级CCM-BOOST功率因数校正电路。首先对有源功率因数校正电路进行了详细的分析。基于对有源功率因数校正电路的双级式和单级式结构的特点比较，本文采用了单级式的电路结构。选择Boost电路为有源功率因数校正电路的主电路，给出了Boost电路的组成并分析了它的工作过程。在此基础上本文采用连续导电工作模式(CCM)和平均电流控制策略，并应用DSP作为有源功率因数校正电路的控制芯片。对TMS320LF2407A芯片的工作原理及各引脚功能作了介绍，对相应的控制部分的控制输入、乘法器、电压环和电流环部分进行了详细的分析。最后，在上述对有源功率因数校正电路做了优化基础上，在输入电压为市电220V/50Hz条件下，对有源功率因数校正电路进行优化，输出400V直流电，并应用MATLAB软件进行了仿真计算。 关键词：功率因数校正PFC技术；MATLAB仿真；Boost电路 PAGE II Abstract A single stage CCM-BOOST power factor correction circuit with high power factor and low electromagnetic interference is designed in this paper. First of all, the active power factor correction circuit is analyzed in detail. Based on the comparison of the two stage and single stage structures of the active power factor correction (APFC) circuit, a single stage circuit is adopted in this paper. The Boost circuit is selected as the main circuit of the active power factor correction circuit, and the composition of the Boost circuit is given and its working process is analyzed. On this basis, the continuous conduction mode (CCM) and the average current control strategy are adopted in this paper, and DSP is used as the control chip of active power factor correction circuit. The working principle of TMS320LF2407A chip and the functions of each pin are introduced. The control input, multiplier, voltage loop and current loop part of the control part are analyzed in detail. Finally, based on the above optimization of active power factor correction circuit, the active power factor correction circuit is optimized under the condition of input voltage of 220V/50 Hz, and 400V DC power is output, and the simulation is carried out by using MATLAB software. Key words: power factor correction (PFC) PFC technology; MATLAB simulation; Boost circuit PAGE III 目 录 TOC \o 1-3 \h \z \u 摘要 I Abstract II 1、前言 1 1.1研究背景及意义 1 1.2研究价值 1 1.3国内外研究现状 1 1.4研究方法 3 2、基于DSP的PFC数字系统采样硬件设计 4 2.1数字控制平台选取及外围电路设计 4 2.1.1 DSP控制器的选用 4 2.1.2 时钟模块硬件电