- 1、本文档共83页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
In?uence of creases
In?uence of creases: Like all T-splines and NURBS control points,
creased control points in?uence the surface within a two face
region. This means if only one edge is creased, the next two edges
in the loop will be partially creased, and the third edge away in the
loop will not be creased at all.
a. Edge to be creased b. After crease
c. Enlarged image of (b) with Zebra stripes. How the crease blends into the surface. 1: Creased
edge. 23: Edges partially creased from the in?uence of (1). 4: Beyond the region in?uenced by
the crease, a smooth surface.
81
Crease behavior near star points: The in?uence of creases produ-
ces some undesirable e?ects near star points. If any edge of a star
point is creased, all the edges going out of the star point will be
creased as well—and so will points up to three edges away. Thus,
it is recommended to either crease all edges of a star point or no
edges of a star point—or, to just use the tsInsertEdge command to
insert a soft crease near the star point.
Edge of a T-spline box Sharp crease added with tsCrease. Tangency handles appear
(when set to visible in tsOptions). Notice the crease also
extends down the third edge of the star point.
Soft creases
Sometimes when “creases”are prescribed, a tight radius edge, ra-
ther than a perfectly sharp crease, is desired. Soft creases, also refe-
rred to as “edge weighting”by polygonal modelers, can be created
with the tsInsertEdge command.
Sharp crease (tsCrease) Soft crease (tsInsertEdge)
82
A soft crease on a corner: Rather than insert a sharp crease, insert
an edge. Inserting these edges close to the original edge will provi-
de an e?ect of a soft crease
Edge of a T-spline box Edge loop (highlighted) inserted with tsIn-
sertEdge for a tight radius (.05)
Edge loop inserted with tsInsertEdge for
tight radius (.2)
Edge loop inserted with tsInsertEdge for
tight radius (.4)
A soft crease on an extrusion: When extruding a column, you can
control the curvature on the top and th
文档评论(0)