ASMESECTIONIIBSB-395SB-395M-2009 国外国际规范.pdf

2009b SECTION II, PART B SB-395/SB-395M SPECIFICATION FOR U-BEND SEAMLESS COPPER AND COPPER-ALLOY HEAT EXCHANGER AND CONDENSER TUBES SB-395/SB-395M (Identical with ASTM Specification B 395/B 395M-02 except for editorial corrections to Table 7. Certification and a test report have A09 been made mandatory.) 1. Scope C71000 . . . 80-20 copper-nickel 1.1 This specification establishes the requirements for C71500 . . . 70-30 copper-nickel C71520 . . . 70-30 copper-nickel- condenser, evaporator, and heat exchanger U-bends that are (modified for welding) manufactured from seamless copper and copper alloy tube. C72200 . . . copper-nickel 1.2 Units — The values stated in either inch-pound units A Designations listed in Classification B 224. or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The 1.5 The following pertains only to the test method values stated in each system are not exact equivalents; described in Sections 11 and 15, of this specification: This therefore, each system shall be used independently of the standard does not purport to address all of the safety other. Combining values from the two systems could result concerns, if any, associated with its use. It is the responsi- in nonconformance with the sp