ASMESECTIONIIBSB-164-2009 国外国际规范.pdfVIP

2009b SECTION II, PART B SB-164 SPECIFICATION FOR NICKEL-COPPER ALLOY ROD, BAR, AND WIRE SB-164 [Identical with ASTM Specification B 164-03(R08) except that certification and reporting have been made mandatory and lot definition is revised.] A08 A09 1. Scope 2.2 Military Standards: 1.1 This specification covers nickel-copper alloys UNS MIL-STD-129 Marking for Shipment and Storage N04400 and N04405 in the form of hot-worked and cold- MIL-STD-271 Nondestructive Testing Requirements for Metals worked rod and bar in the conditions shown in Table 1 and cold-worked wire in the conditions shown in Table 2. 1.2 The values stated in inch-pound units are to be 3. Terminology regarded as the standard. The values given in parentheses 3.1 Definitions of Terms Specific to This Standard: are for information only. 3.1.1 bar — material of rectangular (flats), hexago- 1.3 This standard does not purport to address all of nal, or square solid section up to and including 10 in. (254 mm) in width and 1 the safety concerns, if any, associated with its use. It is ⁄ 8 in. (3.2 mm) and over in thickness the responsibility of the user of this standard to become