UL 999F BULLETIN-2-2008 国外国际规范.pdf

Subject 999F November 11, 2008 SUMMARY OF TOPICS The following changes in requirements to the Standard for Fused Power-Circuit Devices, UL 999F, are being proposed: 1. Clarification of Requirements for Permanence of Marking 2. Editorial Correction to Table 24.1 3. Correction of Cross Reference Error in Clause SB11.4 4. Editorial Revisions to 41.60 and 41.61 5. Revisions to 28.5 to Clarify Test Method STP BALLOTS DUE: DECEMBER 28, 2008 COMMENTS DUE: DECEMBER 28, 2008 For your convenience in review, proposed additions to existing requirements are shown underlined and proposed deletions are shown lined-out. 1. Clarification of Requirements for Permanence of Marking RATIONALE Proposal submitted by: Paul Barnhart, UL Paragraph 42.1 requires labels to be investigated and found suitable for the application. Additionally, paragraph 2.1 requires components to comply with Appendix a. While there is a reference to UL 969 in Appendix A, it would be much clearer to make the reference in paragraph 42.1 rather than using the words ″suitable for the application″ without further explanation. PROPOSAL 42.1 A marking shall be molded, die-stamped, paint-stenciled, stamped or etched metal that is permanently secured, or indelibly applied lettering on a label secured by adhesive that, upon investigation, is found to be acceptable for the application. An adhesive label system shall comply with the Standard for Marking and Labeling Systems, UL 969. Ordinary usage, including likely exposure to weather and other ambient conditions, handling, storage, and the like of the equipment is considered in the determination of the acceptability of the application. SUBJECT 999F -2- NOVEMBER 11, 2008