SFF 8431简介与SFI电气参数测试.ppt

4. Waveform Databases Eye Diagram Test by DSA8200 Notes ： Select the math we had defined as the waveform database and choose the infinite mode to display it. 5. Mask Setting Eye Diagram Test by DSA8200 Notes ： Select our aimed eye mask in the drop-down menu or import customer mask we had defined. SFF-8431 簡介及 SFI 電氣參數測試 Agenda ? Introduction of SFF-8431 ? SFF-8431 Standard Compliance Test of SFI ? Eye Diagram Test by DSA8200 Introduction of SFF-8431 ? BRIEF INTRODUCTION OF SFF-8431 The specification of SFF-8431 defines the electrical interfaces and their test methods between the SFP+ module and host board for operation up to 11.1 GBd. The high speed electrical interface between the host and SFP+ module is called “SFI”. SFI simplifies the module and leverages host based transmit pre-emphasis and host based receive equalization to overcome PCB and external media impairments. SFI typically operates with one connector at the module interface and up to about 200 mm of improved FR4 material or 150 mm of standard FR4. The electrical interface is based on high speed, low voltage AC coupled logic with a nominal differential impedance of 100 Ω. The SFP+ specifications includes management, low speed signal, high speed signal, connector (defined by SFF-8083), mechanical (defined by SFF-8432), and appendices providing parameter and test board definitions, and implementation and measurement descriptions. Introduction of SFF-8431 ? The SFP+ SUPPORTED STANDARDS Introduction of SFF-8431 ? POWER SPECIFICATIONS OF SFP+ ? The module signal ground contacts VeeR and VeeT should be isolated from module case . ? At host power up the host shall supply VccT and VccR to the module within 100 ms of each other. ? SFP+ low speed signaling is based on Low V oltage TTL (LVTTL) operating with a module supply of 3.3 V +/-5% and with a host supply range of 2.38 to 3.46 V