MSS SP-58- 管道吊架和支架─材料、设计和制造.doc

MSS SP-58-2009 管道吊架和支架─材料、设计和制造 MSS SP-58-2009 Pipe Hangers and Supports ?Materials, Design, Manufacture, Selection, Application, and Installation Standard Practice Developed and Approved by theManufacturers Standardization Society of the Valve and Fittings Industry, Inc 127 Park Street, NE Vienna, Virginia 22180 .mss-hq.org Phone: 703 281-6613Fax: 703 281-6671 E-mail: info@mss-hq.org MSS STANDARD PRACTICE SP-58This MSS Standard Practice was developed under the consensus of the MSS Technical Committee 403 and theMSS Coordinating Committee. The content of this Standard Practice is the result of the efforts of competent and concerned volunteers to provide an effective, clear, and non-exclusive specification that will benefit the industry as a whole. This MSS Standard Practice is intended as a basis for common practice by the manufacturer, the user, and the general public. The existence of an MSS Standard Practice does not in itself preclude the manufacture, sale, or use of products not conforming to the Standard Practice. Mandatory conformance is established only by reference in a code, specification, sales contract, or public law, as applicable Unless otherwise specifically noted in this MSS SP, any standard referred to herein is identified by the date of issue that was applicable to the referenced standards at the date of issue of this MSS SP. See Annex C. U.S. customary units in this SP are the standard, the metric SI units are only for reference In this Standard Practice all notes, annexes, tables, and figures are construed to be essential to the understanding of the message of the standard, and are considered part of the text unless noted as "supplemental". All appendices appearing in this document are construed as "supplemental". Supplemental" information does not include mandatory requirements This document has been substantially revised from the previous 2002 edition, INCLUDING THE ADDITION OF INFORMATION FRO