根据ccm单相boost-pfc电路设计与仿真.pdf

基于 CCM 的单相 Boost PFC 电路的设计与仿真 摘要 近年来，为了避免“电网污染”，如何抑制谐波电流、提高功率因数成了备受关注的 问题，而有源功率因数校正技术正是行之有效的方法。尤其是在单相Boost 型电路中得 到了广泛的应用。它是在桥式整流器与负载接一个 DC-DC 变换器，应用控制电路的电压 电流双环反馈，使电网输入电流波形趋于正弦化且相位保持与输入电压相同，从而大幅 降低THD,使得 PF 接近于 1。交流输入电压通过全桥后，得到全波整流电压，再经过MOS 管的开关控制使输入电流自动跟随输入电压基准的正弦化脉动，并获得稳定的升压输出， 给负载提供直流电压源。 本文先简要介绍了功率因数校正技术的现状与发展，着重讨论了有源功率因数校正的 原理、拓扑结构、控制方式等内容，然后对控制器 UC3854 进行了简单的构造分析，最后 设计出基于 UC3854 芯片 CCM 工作模式的 Boost PFC 电路。 关键词：有源功率因数校正，Boost 变换器，电流连续模式，平均电流控制，UC3854 ABSTRACT In recent years, in order to avoid grid pollution, how to suppress the harmonic current, improve the power factor has become a concern, and active power factor correction technology is an effective method. Especially in single-phase Boost-type circuit has been widely used. It is in the bridge rectifier and the load connected to a DC-DC converter, the application of the control circuit voltage and current double loop feedback, so that the grid input current waveform tends to be sinusoidal and phase to maintain the same with the input voltage, thereby significantly reducing the THD, making PF close In 1. AC input voltage through the full bridge, the full-wave rectifier voltage, and then through the MOS tube switch control so that the input current automatically follows the input voltage reference sinusoidal pulsation, and obtain a stable boost output to the load to provide DC voltage source. In this paper, the present situation and development of power factor correction technology are briefly introduced. The principle, topology and control mode of active power factor correction are discussed emphatically. Then, the simple structure analysis of controller UC3854 is carried out. Finally, Chip CCM operating mode Boost PFC circuit. Keywords