欧洲标准化委员会ISO_TS_15011-6 - Cor 1 - 2012.pdfVIP

HZN • Đuro Đaković Termoenergetska postrojenja d.o.o. HZN broj: 166-2014 • 2014-02-03 Zabranjeno umnožavanje u bilo kojem obliku i na bilo koji način bez pisane dozvole HZN-a. TECHNICAL SPECIFICATION ISO/TS 15011-6:2012 TECHNICAL CORRIGENDUM 1 Published 2012-09-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION  МЕЖДУНАРОДНАЯОРГАНИЗАЦИЯПОСТАНДАРТИЗАЦИИ  ORGANISATION INTERNATIONALE DE NORMALISATION Health and safety in welding and allied processes — Laboratory method for sampling fume and gases — Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding TECHNICAL CORRIGENDUM 1 Hygiène et sécurité en soudage et techniques connexes — Méthode de laboratoire déchantillonnage des fumées et des gaz — Partie 6: Procédure pour la détermination quantitative des fumées et des gaz générés par le soudage par résistance par points RECTIFICATIF TECHNIQUE 1 Technical Corrigendum 1 to ISO/TS 15011-6:2012 was prepared by Technical Committee ISO/TC 44, Welding and allied processes, Subcommittee SC 9, Health and safety. ICS 13.100; 25.160.10 Ref. No. ISO/TS 15011-6:2012/Cor.1:2012(E) © ISO 2012 – All rights reserved Published in Switzerland HZN • Đuro Đaković Termoenergetska postrojenja d.o.o. HZN broj: 166-2014 • 2014-02-03 Zabranjeno umnožavanje u bilo kojem obliku i na bilo koji način bez pisane dozvole HZN-a. ISO/TS 15011-6:2012/Cor.1:2012(E) Page 16, Table C.1 Increase the values in the Electrode force column 10-fold, so that the table reads as follows. Ta