高速多轴加工经典举例1.pptVIP

狭槽的 5 轴加工 5-Axis Machining of Slots ? 3 轴加工球刀清角时会留下圆角，必 须手动加刀路清出直角 Using 3-axis machining will leave a fillet in the corners. The corner must then be finished by hand ? 5 轴加工则可用平底刀清出利角，无 需在再后续电极清角 Using 5-axis machining with an end-mill leaves a sharp corner, needing minimal hand finishing ? 不用后续电极清角就意味着节省时 间提高加工质量 The reduction in hand finishing saves time and improves quality Swarf 加工 Swarf Machining ? Swarf 加工使用刀具侧刃切削 Swarf Machining cuts with the side of the tool ? 由于切削刀具是直刃，所以只 能加工可展开的曲面（直纹面） It can only be used with developable surfaces as cutter side is straight ? 切削的深度可由下切步距和曲