NEMAIEC60974-5-2009 国外国际标准规范.pdfVIP

ANSI/IEC 60974-5-2009 American National Standard for Arc Welding Equipment Part 5: Wire Feeders --``,`,,``,,`,`,``,,`,,,`,,,,`,-`-`,,`,,`,`,,` Approved as an American National Standard ANSI Approval Date: April 13, 2009 Adoption of IEC 60974-5, Ed. 2 (2007) ANSI/IEC 60974-5-2009 Arc Welding Equipment— Part 5: Wire Feeders Published by National Electrical Manufacturers Association 1300 North 17th Street, Suite 1752 Rosslyn, Virginia 22209 © Copyright 2009 by the National Electrical Manufacturers Association. All rights including translation into other languages, reserved under the Universal Copyright Convention, the Berne Convention for the Protection of Literary and Artistic Works, and the International and Pan American Copyright Conventions. These materials are subject to copyright claims of IEC, ANSI, and NEMA. Not for resale. No part of this publication may be reproduced in any form, including an electronic retrieval system, without the prior written permission of NEMA. All requests pertaining to the ANSI/NEMA Standard should be submitted to NEMA. --``,`,,``,,`,`,``,,`,,,`,,,,`,-`-`,,`,,`,`,,` NOTICE AND DISCLAIMER The information in this publication was considered technically sound by the consensus of persons engaged in the development and approval of the document at the time it was developed. Consensus does not necessa