欧洲标准化委员会BS EN 00714-1995.pdfVIP

BRITISH STANDARD BS EN 714:1995 BS 2782-11: Method 1123F:1995 Thermoplastics piping systems — Non-end-load-bearing elastomeric sealing ring type joints between pressure pipes and moulded fittings — Test method for leaktightness under internal hydrostatic pressure without end thrust The European Standard EN 714:1994 has the status of a British Standard UDC 621.643.4-036.074:621.643.2-98:62-76:620.165.29 BS EN 714:1995 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee PRI/61, Plastics piping systems and components, upon which the following bodies were represented: British Gas plc British Plastics Federation British Plumbing Fittings Manufacturers’ Association British Valve and Actuator Manufacturers’ Association Department of the Environment (British Board of Agrément) Department of the Environment (Building Research Establishment) Department of the Environment (Property and Buildings Directorate) Department of Transport Electricity Association Federation of Civil Engineering Contractors Health and Safety Executive