errata_591分享 文档 参考 学.pdfVIP

INTEGRATED CIRCUITS ERRATA SHEET Type: P8xC591Vxx/00 Document Release: V1.1 Date: 2000-08-07 This errata sheet describes functional anomalies and parametrical deviations from the type specification known at the time of the release of this document. Each anomaly and deviation is assigned a number and its history tracked at the end of the document. Functional Deviations Identification: The typical P8xC591Vxx/00 devices have the following marking (top): Line 1 P8xC591VFx/00 Line 2 [batch number] Line 3 [manufacturing / date code] INTEGRATED CIRCUITS Deviation 1: CAN Reset Mode An anomaly has been found in the CAN part of the device. This anomaly refers to the CAN reset mode (software reset). The external (hardware-) reset is not affected! Description The anomaly may occur whenever the user software enters the reset mode during normal operation or if the CAN controller enters the bus-off state. In this case, the Receive Buffer Status and the Receive Message Counter are reset as specified. However, internal pointers for the RX FIFO and the Transmit Buffer are not reset correctly. As a consequence of this proper operation of the CAN controller after re-entering into operation mode is not given in all cases. Work-around: 1.) It is strongly recommended to empty the RX FIFO before going into CAN reset mode. This is performed with the ‘Release Receive Buffer‘command. 2.) Entering CAN reset mode during a transmission (Transmit Status = 1) or reception (Receive Status = 1) is not allowed! A pending CAN transmission must be terminated (waiting for successful transmission or abort transmission) before the P8xC591VFx/00 may change into the CAN reset mode. The code for the two cases would look like this: do {