USCAR-1 紧固件的盐雾试验和评价方法Rev 1.pdfVIP

SAE/USCAR-1 Revision 1 Issued December 1996 Revised March 2005 SALT SPRAY TESTING AND EVALUATION OF FASTENER FINISHES 1. SCOPE: This procedure is used to test and evaluate the resistance of fastener surface finishes to laboratory salt spray testing. 2. REFERENCES: 2.1 ASTM Publications: Available from ASTM, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959. ASTM B 117 ASTM D 610 3. APPARATUS: 3.1 Salt Spray Cabinet: The salt spray cabinet and operating conditions shall meet the requirements of ASTM B 117 except as noted herein. 3.2 Sample Holders: Sample holders shall be made of an inert corrosion resistant material such as acrylic, polyvinyl chloride or similar material. The holder size and thickness depends upon the size and number of fasteners being tested. No wood shall be used in the construction of sample holders as the sap acidity can affect the corrosion result. The research data, analysis, conclusion, opinions and other contents of this document are solely the product of the authors. Neither the Society of Automotive Engineers, Inc. (SAE) nor the United States Council for Automotive Research (USCAR) certifies the compliance of any products with the requirements of nor makes any representations as to the accuracy of the contents of this document nor to its applicability for purpose. It is the sole responsibility of the user of this document to determine whether or not it is applicable for their purposes. Copyright 2005, USCAR All rights reserved.