目视检验规范IPC610剖析剖析.pptVIP

目視檢驗規范IPc610 PQC RUI LI 2010/1/20  目視檢驗規范標准IPC610 1.允收標准 2.拒收標准  零件本體僅下方有二接觸點的零件 (Chip Components/Bottom Only Terminations cont )-Hfs(Shift) 允收( Target Condition) 允收極限( Acceptable)拒收( Nonconforming Defect ·零件黏焊於錫墊中心位置 ·零件往錫墊寬邊(A偏移,但寥件·零件往錫墊寬邊(A)偏移,且零 沒有任何偏移 本體寬邊(C)有75%以上焊接於件本體小於75%寬邊(C)焊接 錫墊上 零件本體與電路板錫墊間(G錫·零件往錫墊長邊(B)偏移. 厚至少0.2mm No side overhang is allowed if hang(A)is allowed it inimum end joint width (C) end joint width(C) ents are Imet can be demonstrated with reduced demonstrated with reduced clearance  零件本體有1,3,5面矩形金屬焊接點 (Rectangular End Components-1, 3or5 side