环境工程印染废水毕业设计计算书及说明书范文.docx

毕业论文（设计）正文 题目： 10000m 3/d 印染废水处理工程方案设计 3 Design of 10000m/d printing and dyeing wastewater treatment project 学 院：环境科学与工程 专 业：环境工程 班 级： 学 号： 学生姓名： *** 指导教师： *** 二○一六年五月 3 10000m/d 印染废水处理工程方案设计 摘 要 : 本文对浙江一家专业从事染整加工和伞面绸生产的民营企业印染废水处 3 理工程进行方案设计。设计规模为 10000m/d ，进水水质 COD≤1000 mg/L， BOD≤250 mg/L ，SS≤200 mg/L ，色度≤ 500 倍。产品以涤纶为主，无单独高浓度废水。设计采用水解酸化 +生物接触氧化作为主体工艺，出水可以达到《纺织染整工业水污染物排放标准》（ GB 4287-2012）中的新建企业直接排放标准。 关键词： 印染废水；水解酸化；生物接触氧化 Design of 10000m 3/d printing and dyeing wastewater treatment project Abstract: In this paper, a professional silk dyeing processing and production of private enterprises umbrella printing and dyeing wastewater treatment program designed in Zhejiang .The designed scale 3 is 10000m/d, and the average concentration of COD , BOD, SS , Chroma from inflow are less than 1000 mg/L,250 mg/L,200 mg/L and 500 times respectively. Polyester fibre is the main products, with no separated high-strength concentration of wastewater. Hydrolysis acidification and biological contact oxidation was designed as the main technology, the effluent concentration of COD, BOD, SS, Chroma is less than 200 mg/L,50 mg/L,100 mg/L and 80 times effluent can reach the "Discharge standards of water pollutants for dyeing and finishing of textile industry"(GB 4287-2012) in the newly established enterprises direct emission standards. Key words: Printing and dyeing wastewater; Hydrolytic acidification; Biological contact oxidation 目录 1. 引言 ..................................................... Ⅰ﹣ 0 设计背景及意义 ......................................... Ⅰ﹣ 0 处理技术分析 ........................................... Ⅰ﹣ 0 设计思路 ............................................... Ⅰ﹣ 0 2. 项目概述 ................................................. Ⅰ﹣ 1 设计原则 ............................................... Ⅰ﹣ 1 设计依据 ............................................... Ⅰ﹣ 1 设计任务 ............................................... Ⅰ﹣ 2 设计水质水量 ....................................... Ⅰ﹣ 2 设计排放标准 ..................