110KV变电站设计(2020年).docxVIP

110KV变电站设计 学院： 专业： 年级： 指导老师： 学生： 日期： 摘要： 本文主要进行 110KV 变电站设计。首先根据任务书上所给系统及线路 和所有负荷的参数， 通过对所建变电站及出线的考虑和对负荷资料分析， 满足安 全性、经济性及可靠性的要求确定了 110KV、35KV 、10KV 侧主接线的形式， 然后又通过负荷计算及供电围确定了主变压器台数、 容量、及型号， 从而得出各 元件的参数， 进行等值网络化简， 然后选择短路点进行短路计算， 根据短路电流 计算结果及最大持续工作电流，选择并校验电气设备，包括母线、断路器、隔离 开关、电压互感器、电流互感器等，并确定配电装置。根据负荷及短路计算为线 路、变压器、 母线配置继电保护并进行整定计算。 本文同时对防雷接地及补偿装 置进行了简单的分析，最后进行了电气主接线图及 110KV 配电装置间隔断面图 的绘制。 关键词： 变电站设计，变压器，电气主接线，设备选择 Abstract: This paper mainly carries on the design of 110KV substation. According to the mandate given by the system and the load line and all parameters of the substation and line consideration and the data of load analysis, meet the safety, economy and reliability requirements of 110KV, 35KV, 10KV side of the main connection form is determined, and then through the load calculation and determine the scope of supply the number, size, and type of the main transformer, thus obtains the parameters of each element, the equivalent network simplification, and then select the short circuit short circuit calculation, the calculation results and the maximum continuous working current according to short-circuit current, selection and calibration of electrical equipment, including bus, circuit breaker, isolating switch, voltage transformer, current transformer etc., and determine the distribution device. According to the load and short circuit calculation for the line, transformer, bus configuration of relay protection and setting calculation. At the same time, this paper makes a simple analysis of lightning protection and grounding and compensation device, and finally carries out the electrical main wiring diagram and the 110KV distribution unit interval section drawing. Key words: substation design, transformer, electrical main wiring, equipment selection 目录 TOC \o 1-5 \h \z \o Current Document 引言 1 \o Current Document 变电站的作用 1 \o Current Document 我国变电站及其设计的发展趋势 2 \o Current Document 变电站设计的主要原则和分类 5 \o Current Document 选题目的及意义 6 \o Current