风力发电塔筒法兰平面度检测作业指导书.docx

平面度检测作业指导书 1.0 范围 Scope This work instruction describers how to measure the flange flatness and tilt on tower sections and foundations.The instruction also describes how to use the Flange calculator and how to report measurements. 该作业指导书规定了塔筒和基础段法兰平面度及内倾的检测方法，规定了法兰平面度计算公 式如何使用、法兰平面度报告如何出具。 2.0 概述 General The work instruction is based on the usage of Easy-laser series D or E from Damalni as the measureme nt too该作业指导书的编制依据是丹麦 Easy-laser的使用规范 Further information can bmente found in the manual:installation & trouble shooting guideline. 3.0 测量工具 Measurement Tools -Check that the Easy-Laser system is complete and consists of the following parts: -Display unit -Laserer spinner -Laser detector with distance screws mounted.The screws must not be of magnetic type -Cable from detector to display(D) -Bluetooth unit for laser detector(E) -Check availability of the following -Measureement tape with magnet -Chalk for marking -Light source -Working platform -Check that the Easy-Laser system has been calibrated within 12 months. 4.0 Prepare flange calculator Excel sheet -Start the Flange calculator excel sheet named“Flange calculator8.xls” -Enter the Operator initials -Select”Final measuremen”t,”Test measurement-1 row”or “Test measurement-2 row” -Select the correct measurem. Equipment -Enter the equipment serial number -Enter latest calibration date of equipment -Check that the detector offset is correct -Enter section ID number -Enter the welding drawing number -Select the flange-bottom or top flange -Select an empty field in the excel sheet -Press Continue to proceed “Final inspection measurement”is the final flange measurement when all weldings are completed and NDT approved Test measurement — 1 row is performed after tack welding of the flange to check the flange flatness. Test measuremen—2 row” is done where appropriate and before NDT test Offset has to reflect the actual detector used in order to ensure valid measurements. Section ID number has to reflect the number entered in