用hyperlynx实现SI仿真的办法和步骤.pdfVIP

用HyperLynx实现SI仿真的步骤 Preface HyperLynx is a powerful electromagnetic analysis tool, which is more and more popularly used in many hardware design fields. With HyperLynx, we can perform : ① Impedance calculation ②LineSim(simulation before route) ③Crosstalk analysis before route ④ Interactive Board Simulation (BoardSim) a). Crosstalk b). Power-Integrated analysis c). Signal-Integrated analysis d). EMC analysis e). Differential and GHz simulation Here, we just talk about how to do SI analysis of BoardSim. (Based on HyperLynx 8.1.1) Steps ①Open the completed PCB file with Expedition ②Export board file to HyperLynx then, come to HyperLynx window ③Setup board parameter, i.e. stackup, via model, and power supplies you can calculate your impedance with stackup parameter Select your via model, default model or define your own model. Generally, we choose default value. Edit your voltage level of power rails in your board. ④select signals that are supposed to be simulated Picture on right side, HDMI differential signals have been highlighted and one pair of them been selected. you have two ways to do simulation a). click SI command, as below pic. b). export free-form schematic of the net to LineSim window. By doing this way , you can check your net parameter , such as impedance, length, via model and net topology and so on , you could edit them, too. ⑤Assign model to your key components. i.e. ICs, source, sink, etc. Generally, you could get your IC’s IBIS model from supplier. Model is the soul of simulation, which influences accuracy of result directly. ⑥ Open SI oscilloscope to simulate. On the panel of oscilloscope, you can setup your simulating parameter, i.e. frequency, duty, stimulus, operation type(standard or eye diagram). and you could define your differential probes, too. ⑦ check out your output waveforms.