低剖面宽带开槽微带天线的研究与设计.pptxVIP

低剖面宽带开槽微带天线的研究与设计;度为 L，宽度为 W，沿贴片的边缘平行方向开了一 对对称的弯折槽，弯折槽由两部分组成，分别为 L1 和 L2，其中 L2 段平行于非辐射边，距离非辐射边 间距为 W1，L1 段平行于辐射边，距离辐射边间距 为 W2，两段槽缝的宽度均为 Ws，底部嵌入贴片的 微带线宽度为 W3，长度为 L3，距离底边间距为 L4， 馈电点的位置在矩形贴片中线上，距离底边间距为 L5。贴片印制在介电常数为 4.4，厚为 3mm 的 FR4 介质板上。 对称的弯折槽结构可以激励起一个与基模 TM10 相邻的谐振模TM?0（1?2）[2]，尾部加载的小段微 带线可以激励起另一个与之相邻的谐振模[3]，这三个 谐振模具有相似的辐射特性和相同的极化特性。;尺寸，加工制作了一副天线，对其进行实验测试。 表 1 宽带开槽微带天线结构尺寸表;矩形贴片有所降低。;·5·;range of temperature, they require an even higher level of reliability because making repairs in space is both costly and difficult. Therefore, dielectric materials will need to be both reliable and high performance so that very high-resolution and highly accurate radar imagery can be achieved under all operating conditions. Ⅱ SELECTION OF DIELECTRIC MATERIALS;metal cladding in laminates (i.e. the choice of electrodeposited (ED) copper, reverse treated ED copper or rolled-annealed (RA) copper) and metal conductivity, but also the copper profile/roughness and trace resolution or oxidation from processing. As a dielectric material, polytetrafluoroethylene (PTFE) is a near ideal material for microwave circuit boards because of its outstanding electrical properties at high frequencies. Electrically, fiberglass reinforced PTFE-based laminates such as Arlon DiClad 880 or CuClad 217, Taconic TLY-5, and Rogers RT/duroid? 5880 provide extremely low loss characteristics. However, since these laminates have very high amounts of PTFE resin content, they have a relatively high coefficient of thermal expansion (CTE) and a thermal coefficient of dielectric constant (TCEr) on the order of -150 ppm/°C. To account for laminate dielectric loss in finished circuit boards, moisture absorption and processing solution exposure need to be considered. Ⅲ EFFECTS FROM MOISTURE AND PROCESSING;TC600. They were developed to provide consistent dielectric constant not only near the PTFE phase change but also throughout a much wider operating temperature range. In addition to dielectri