嵌入式系统基础 项目七：通用GPIO编程 按键程序main.c.docx

嵌入式系统基础延伸阅读 嵌入式系统基础 按键程序main.c #include utils.h #include s3c6410_addr.h unsigned short value = 0; //用来保存从端口读取的按键状态 static void Delay(void) //延时函数 { volatile unsigned int k; //定义临时变量 for(k = 0; k 200000; k++); //通过for循环计数实现延时功能 } void KeyScan(void) //按键扫描函数 { value = ((unsigned short)rGPNDAT) 0x3F; //读取GPN端口状态，并只取GPN5～0位 if(value != 0x3F) //判断是否有按键被按下 { Delay(); //消除抖动 value = ((unsigned short)rGPNDAT) 0x3F; //重新读取端口状态 if(value != 0x3F) //再次判断是否有按键被按下 { if(!(value 0x1)) //GPN0引脚接按键K1 { Uart_SendString(K1 is pressed!\r\n); } if(!(value 0x2)) //GPN1引脚接按键K2 { Uart_SendString(K2 is pressed!\r\n); } if(!(value 0x4)) //GPN2引脚接按键K3 { Uart_SendString(K3 is pressed!\r\n); } if(!(value 0x8)) //GPN3引脚接按键K4 { Uart_SendString(K4 is pressed!\r\n); } if(!(value 0x10)) //GPN4引脚接按键K5 { Uart_SendString(K5 is pressed!\r\n); } if(!(value 0x20)) //GPN5引脚接按键K6 { Uart_SendString(K6 is pressed!\r\n); } while(value != 0x3F) //通过该循环判断按键是否松开 { //读取端口状态 value = ((unsigned short)rGPNDAT) 0x3F; } } } } int _main(void) { Port_Init(); //与按键有关的寄存器初始化 Uart_Init(); //UART相关寄存器初始化 Uart_Printf(\n********************\n); Uart_Printf( Key Test！); Uart_Printf(\n********************\n); for(;;) { KeyScan(); //调用按键扫描函数 } return 0; }