（汽车行业）毕业设计汽车轴盖冲压模设计.pdf

（汽车行业）毕业设计汽 车轴盖冲压模设计 摘 要 随着中国工业不断地发展，模具行业也显得越来越重要。本文针对 端盖的冲裁工艺性和拉深工艺性，分析比较了成形过程的三种不同冲压工 艺（单工序、复合工序和连续工序），确定用一幅复合模完成落料、拉深 和冲孔的工序过程。介绍了端盖冷冲压成形过程，经过对端盖的批量生产、 零件质量、零件结构以及使用要求的分析、研究，按照不降低使用性能为 前提，将其确定为冲压件，用冲压方法完成零件的加工，且简要分析了坯 料形状、尺寸，排样、裁板方案，拉深次数，冲压工序性质、数目和顺序 的确定。进行了工艺力、压力中心、模具工作部分尺寸及公差的计算，并 设计出模具。还具体分析了模具的主要零部件（如凸凹模、卸料装置、拉 深凸模、垫板、凸模固定板等）的设计与制造，冲压设备的选用，凸凹模 间隙调整和编制一个重要零件的加工工艺过程。列出了模具所需零件的详 细清单，并给出了合理的装配图。通过充分利用现代模具制造技术对传统 机械零件进行结构改进、优化设计、优化工艺方法能大幅度提高生产效率， 这种方法对类似产品具有一定的借鉴作用。 关键词 ：端盖；模具设计；复合模；拉深冲孔 ABSTRACT With Chinas industries continue to develop and die industry is also becoming increasingly important. Based on the Cover of the stamping process and the deep drawing process, Comparative analysis of the process of forming three different stamping process (single processes, complex processes and continuous processes) confirm completion of a composite model blanking, drawing processes and punching process. On the cover of the cold stamping process, right after the Cover of the mass production, quality components, and the use of structural components of the analysis, research, in line with lower performance prerequisite to the identification of stampings, Stamping method used to complete the processing components, and a brief analysis of the blank shape, size, layout, the Conference Board, the number of Drawing, stamping processes in nature, number and sequence determination. For the process, the center of pressure, the die size and the tolerance of the calculation, design mold. Also analyzes the mold of the main components (such as punch and die and dump devices, drawing punch, slates, Punch plate, etc.) design and manufacturing, stamping equipment selection, punch-gap adjustment and establishment of a vital p