复合模毕业设计论文.docx

冲压模具在实际工业生产屮应用广泛。在传统的工业生产中，T人生产的劳动强 度大、劳动量大，严重影响生产效率的提高。随着当今科技的发展，工业生产中模 具的使用已经越来越引起人们的重视，而被大量应用到工业生产屮来。冲压模具的自 动送料技术也投入到实际的生产中，冲压模具可以大大的提高劳动生产效率，减轻工 人负担，具有重耍的技术进步意义和经济价值。 本文提出采用模具来生产止动件的新工艺，并针对某规格夹具止动件设计了复合 模。该模具设计的难点主耍是如何解决好零件屮的孔冲裁、确定模具结构、冲裁方案 选定等。本文结合止动件的特点，具体解决了压力机的选择与校核、凸模和凹模刃口 尺寸计算及结构设计、定位方案设计、卸料方式的设计、主耍模具零件的加工工艺、 标准零件的选用、模具的装配等一系列的设计丁作，这些设计可为类似的零件模具设 计提供现实的指导意义。此次模具设计的突岀特点是尝试使用复杂的复合模具，解决 常规冲圧工艺模具套数多、工艺路线长、生产成本高、效率低等缺点，并为以后此类 零件冲压工艺的编制及模具设计提供了可靠的依据。 本文介绍的模具实例结构简单实用，使用方便可靠，对类似T件的大批量生产具 有一定的参考作用。 关键词：冲模 复合模 冲裁力 冲裁间隙 青岛理工大学琴岛学院本科毕业设计（论文） Abstract Punching die has been widely used in industrial production. In the traditional industrial production, the worker work very hard, and there are too much work, so the efficiency is low. With the development of the science and technology nowadays, the use of punching die in the industial production gain more at tention, and be used in the industrial produc tion more and more. Self-acting feed technology of punching die is also used in production, punching die could increase the efficience of production and could alleviate the work burden, so it has significant meaning in technologic progress and economic value. This Article proposes using mold to produce retainer of the new technology, And against a standard fixture retainer design of the compound dies. The main problems of this mold design is how to solve retainer of punching holes, determine mold structure, how to manufacturing the mold and selected blanking programs and so on. This Article Combine the characteristics of retainer, concretely solve the choice and verify check of the press machine, the numera.tion and structure design of the point dimension of punch and matrix, the locating project design, the method of stripper, the main mold parts processing, the choice of standard parts， the design of the model assemble. These designs can provide realistic guiding significance for similar mold design. But the characteristics of the design is to try to using the complicate