安防监控机房应急预案整理.pdf

安徽亿安保全安防系统工程有限公司 中心机房应急处置方案 二〇一三年十一月 ecial lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings anl bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, dadjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tighteneed bolt reaming die reamer, adjustable reamers, boring mill, in several ways.6.4.5.4.1 General requirements before reamin校长为学校学生道路交通安全工作第一责任人，负责校（园）内的道路交通安全管理工作和学生出行的道路交通安全教育，以及学生春游和其他教育教学活动的道路交通安全管理工作center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are withintheprescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into.Center coupling, condenser water filling and waterfilled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm.In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and spd rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisiorawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and withoutscrap iron and greasefree, relative position of the coupling according to