美国耶鲁起重机YALE_TROLLEY_-_FLP2___FLG2_MANUAL.pdf

PRECISION BEARING TROLLEY SERVICE INSTRUCTIONS AND PARTS LIST SECTION O/T3, P01 1/4 THRU 3 TON CAUTION: THE EQUIPMENT ILLUSTRATED AND DESCRIBED IN THIS BULLETIN IS DESIGNED FOR MANUAL OPERATION ONLY AND IS NOT TO BE POWER DRIVEN, NOR IS IT SUITABLE FOR TRANSPORTING PERSONS! This trolley is a relatively simple mechanism requiring comparatively little care, maintenance, inspection and lubrication. The following information is provided to assist in installing and maintaining this equipment. INSTALLATION Sliding the trolley over the open end of the runway beam is the simplest way to install this unit. If an PLAIN TROLLEY GEARED TROLLEY open beam end is not available, one side plate can be removed and the unit can be reassembled on the ADJUSTMENT INSTRUCTIONS: beam. Always verify the trolley is adjusted properly to Beam flange width plus 1/16” running clearance on fit the beam. See the adjustment instructions below. each side of the flange is the correct trolley setting. Always run the unit along the ent ire length of the Move the spacing washers to the inside or outside of runway beam to verify proper operation and the plates as required. clearances. GENERAL MAINTENANCE Thorough inspection is recommended at regular intervals. The frequency of inspection must be determined by the user, since application factors such as duty cycle and ambient conditions will dictate the maintenance requirements of the unit. When inspections are made, the entire trolley should be inspected for wear, or for damage such as may be sustained through severe overloading or impact with other objects. Replace all damaged parts immediately. Check trolley motion along the runway beam, to verify proper operation. LUBR