美国耶鲁起重机YALE_TROLLEY_-_RIGID_MOUNT_MANUAL_TROLLEY_MANUAL.pdf

INSTRUCTIONS AND PARTS LIST RIGID MOUNT I-BEAM AND PATENTED TRACK TROLLEYS (PUSH & HAND GEARED - 1/2 THRU 15 TON RATED LOADS) GENERAL Yale Rigid Mount I-Beam Trolleys are designed especially for use on KEL2, KAL2 Chain Hoists and Series Y80 Electric Wire Rope Hoists. They attach directly to suspension brackets of lug mounted hoists. Trolleys are shipped partially disassembled to make it unnecessary to take them apart before mounting on hoist. This also makes it easier to properly adjust the trolleys to fit the 1 TON RATED LOAD PUSH TYPE TROLLEY particular beams on which they are to operate. Correctly fitted 12688 trolleys travel easier and last longer. Your new Yale Rigid Mount Trolley can be assembled to your hoist and the complete unit then installed on its runway beam with a minimum of effort by following the directions given here. THE INFORMATION CONTAINED IN THIS MANUAL IS FOR INFORMATIONAL PURPOSES ONLY AND YALE DOES NOT WARRANT OR OTHERWISE GUARANTEE (IMPLIEDLY OR EXPRESSLY) ANYTHING OTHER THAN THE COMPONENTS THAT YALE MANUFACTURES AND ASSUMES NO LEGAL RESPONSIBILITY (INCLUDING, BUT NOT LIMITED TO CONSEQUENTIAL DAMAGES) FOR INFORMATION CONTAINED IN THIS MANUAL. 1 TON RATED LOAD HAND GEARED TROLLEY