包包袋子检验.pdf

1.0 GENERAL The conditions described below are the most commonly found and do not necessarily cover all possible conditions.Any other functional or visual non-conditions shall be initially classified according to the following. The following checking list is apply to all kind of bags. 1.0 前言 以下所描述的条件是经常发生及非必要但可能发生的情况， 所有的功能或直观的非条件性的 情况将按以下来分类。 以下项目适用于所有类别的袋子。 2.0 INSPECTION PLAN/ 检验计划 2.1 ANST/ASQC Z1.4-1993 single Sampling plan,General Inspecttion Level Normal II is applied to determine the inspection sample size for aesthetic and functional chek, Special Inspection Level will be applied for safety, reliablitty ,performance or other special test if whereas applicable . ANST/ASQC Z1.4-1993 一次抽样检查方案为：正常的检验标准为确定检查样本大小、 外观及功能；特殊的检验将用于安全、 可靠度、性能或其他合适的测试。 2.2 Sampling Plan should be based on ANST/ASQCZ1.4-1993,(Refer to Appendix A) AQL level: OEM and Brand items Other open items 1. Critical -0 0 2. Major -1.5 2.5 3.Minor -4.0 4.0 抽样检验方法应该根据 ANST/ASQCZ1.4-1993 ， (参见附录 A) AQL 标准： OEM 和品牌项目 其他项目 1. 严重 - 0 0 2. 主要 -1.5 2.5 3. 次要 -4.0 4.0 2.3 Special Instruction: When lot is checked against approved sample,any deviation(material,cosmetic, Construction,performance,packaging etc.)from approval sample must be recorded in detail in the “Remark section of shipment inspection report for disposition. 2.3 特别说明： 当整批货物检验不符合确认样时，任何与确认样不一致的地方包括材料、外观、结构、性 能、包装都必须备注在出货检查报告加以确认。 2.4 Defect Csassification: 2.4.1 Defects are classified into 3categories a) Critical –is a defect that poses a hazardous or unsa