juniperjunossr系列clusterha配置汇总.docxVIP

集团标准化办公室：[VV986T-J682P28-JP266L8-68PNN] 集团标准化办公室：[VV986T-J682P28-JP266L8-68PNN] JuniperJunosSR系列ClusterHA配置汇总 1.插线 指定主备 On device A: set chassis cluster cluster-id 1 node 0 reboot On device B: set chassis cluster cluster-id 1 node 1 reboot 定义控制层端口 （可配置网管口） On device A: {primary:node0} set groups node0 system host-name HQ-CS-FW-SRX550-1 set groups node1 system host-name HQ-CS-FW-SRX550-2 set apply-groups ${node} 义数据层端口 On device A: {primary:node0} -fab0 is node0 (Device A) interface for the data link # set interfaces fab0 fabric-options member-interfaces ge-0/0/2 -fab1 is node1 (Device B) interface for the data link # set interfaces fab1 fabric-options member-interfaces ge-9/0/2 5.配置 redundancy-group {primary:node0} set chassis cluster redundancy-group 0 node 0 priority 100 set chassis cluster redundancy-group 0 node 1 priority 50 set chassis cluster redundancy-group 1 node 0 priority 100 set chassis cluster redundancy-group 1 node 1 priority 50 注： Redundancy Group 0 for the Routing Engine failover properties 必配 Redundancy Group 1 to define the failover properties for the Reth interfaces (all the interfaces will be in one Redundancy Group in this example) 建议所有端口放一个Group 6. 配置 端口监控 On device A: {primary:node0} set chassis cluster redundancy-group 1 interface-monitor ge-0/0/3 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-0/0/4 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-9/0/3 weight 255 set chassis cluster redundancy-group 1 interface-monitor ge-9/0/4 weight 255 注：监控所有端口 Interface monitoring is not recommended for redundancy-group 0. 7.配置 Reth interface 并划入 zone Configure the Redundant Ethernet interfaces (Reth interface) and assign the Redundant interface to a zone. On device A: {primary:node0} # set chassis cluster reth-count max-number Range: 0 through 1 redundancy-group 【group-number】 —Number of the redundancy group on which to initiate