模具设计问题点回复c5392223-part issue comment.pptVIP

C53922/C53923 part issue 此面出模方向倒扣，建议做5度减胶拔模。(另一产品相同更改）This position undercut,we suggest cut 5 angle draft for demold. 1 degree should be ok 此面出模方向倒扣，建议做5度减胶拔模。（后模相应更改，见下页）(另一产品同样更改）Undercut in demolding direction,we suggest cut 5 angle draft for easy demolding(the other part in same changing,the core follow the cavity). 1 degree should be ok 1 degree should be ok 产品这两处模具前模部分孔有倒扣，后模柱子也有倒扣，如果产品此两处没有特殊功能，建议把孔及柱子拉直，简化模具结构提高模具寿命。(另一产品同样更改）Undercut in this hole,also the pillar in core.We suggest make hole and pillar in straight,let mould structure in simple(If the hole and pillar not in special func