【卡特挖机图集】发动机.pdfVIP

8PR - 325B EXCAVATOR - SENR3583-04 (Pub. Date 1994/10/12) Introduction NOTE: For Specifications with illustrations, make reference to Specifications For 3114, 3116 3126 Engines, SENR3582. If the Specifications in SENR3582 are not the same as in the Systems Operation and Testing And Adjusting, look at the printing date on the back cover of each book. Use the Specifications given in the book with the latest date. Metric Fasteners NOTE: Take care to avoid mixing metric and inch fasteners. Mismatched or incorrect fasteners can result in mechanical damage or malfunction, or possible personal injury. Original fasteners removed during disassembly should be saved for assembly when possible. If new ones are required, caution must be taken to replace with one that is of same part number and grade. Metric thread fasteners are identified by material strength (grade) numbers on bolt heads and nuts. Numbers on bolts will be 8.8, 10.9, etc. Numbers on nuts will be 8, 10, etc. Engine Design 3114 Cylinder And Valve Location Bore . . . 105.025 ?.025 mm (4.1348 ?.0010 in) Stroke . . . 127 mm (5.0 in) Displacement 3114 . . . 4.4 liter (268 cu in) Number Of Cylinders 3114 . . . 4 Cylinder Arrangement . . . in-line Valves per Cylinder . . . 2 Valve Lash Setting Intake . . . 0.38 mm (.015 in) Exhaust . . . 0.64 mm (.025 in) Type of Combustion . . . Direct Injection Firing Order: 3114 . . . 1-3-4-2 Direction of Crankshaft Rotation (when seen from flywheel end) . . . counterclockwise NOTE: Front end of engine is opposite the flywheel end. Left side and right side of engine are as seen from flywheel end. No. 1 cylinder is the front cylinder. 3116 Cylinder And Valve