基于at89s51单片机的电子血压计设计毕业设计.pdf

基于 AT89S51单片机的电子血压计设计 摘 要 电子血压计具有易携带、精度高、智能化等特点，随着现代电子技术的发展，电子血 压计呈现出家用化的趋势。 然而传统单片机的电路设计复杂、 稳定性不好、 测量精度不高， 因此本设计首先从血压测量方法切入设计出电路系统，然后以 AT89S51单片机为控制核心， 外围硬件电路由气体压力传感器 US9111、串行 A/D转换芯片 ADC0832、LCD驱动芯片和其他 模拟电路组成，同时采用 KeiluVision2 进行 C语言编程来使硬件满足一个简易血压计的功 能。本文所设计的血压计稳定性高，测量速度快，测量精度高，测试结果基本与水银血压 计一致。 另外，本系统的设计能满足人体健康测量需要， 对提高日常生活质量有很多好处， 具有很高的市场价值。 关键词 : 单片机 血压计 传感器 精度 I The Design of Electronic Sphygmomanometer Based on AT89S51 MCU Abstract The electronic blood pressure monitor is easy to be carried, high accuracy, intelligent features .With the development of modern electronic technology, electronic blood pressure monitor shows the trend of the household. The circuit of the t raditional microcontroller ’s design process is complex, and the stability is not good, as well as that the measurement accuracy is not high. Therefore, to sum up, the method of how to design the circuit system is the blood pressure measurement briefly, and then around the AT89S51 microcontroller development platform, composedof the peripheral hardware circuit by the gas pressure sensor US9111, the serial A/D conversion chip ADC0832, the LCD driver chip and other analog circuits under the preparation of KeiluVision2 the C programming language. This sphygmomanometerdesigned perfect stability, excellent speed, high accuracy, and above all, the test results are basically consistent with the mercury sphygmomanometer. In addition, the design of this system meets the needs of the humanhealth measurement. Moreover, there are manybenefit