信号与系统习题集.docVIP

可修改 欢迎下载 精品 Word 可修改 欢迎下载 精品 Word 可修改 欢迎下载 精品 Word 信号与系统练习题集 第一部分：信号与系统的时域分析 一、填空题 1. ( ). 2. The unit step response is the zero-state response when the input signal is ( ). 3. Given two continuous – time signals x(t) and h(t), if their convolution is denoted by y(t), then the convolution of and is ( ). 4. The convolution ( ). 5. The unit impulse response is the zero-state response when the input signal is ( ). 6. A continuous – time LTI system is stable if its unit impulse response satisfies the condition: ( ) . 7. A continuous – time LTI system can be completely determined by its ( ). 8. ( ). 9. Given two sequences and , their convolution ( ). 10. Given three LTI systems S1, S2 and S3, their unit impulse responses are , and respectively. Now, construct an LTI system S using these three systems: S1 parallel interconnected by S2, then series interconnected by S3. the unit impulse response of the system S is ( ). 11. It is known that the zero-stat response of a system to the input signal x(t) is , then the unit impulse response h(t) is ( ). 12. The complete response of an LTI system can be expressed as a sum of its zero-state response and its ( ) response. 13. It is known that the unit step response of an LTI system is , then the unit impulse response h(t) is ( ). 14. ( ). 15. We can build a continuous-time LTI system using the following three basic operations: ( ) , ( ), and ( ). 16. The zero-state response of an LTI system to the input signal is , where s(t) is the unit step response of the system, then the unit impulse response is h(t) = ( ). 17. The block diagram of a continuous-time LTI system is illustrated in the following figure. The differential equation describing the input-output relationship of the system is ( ). + + -- + 2 3