5G优化案例:数据和语音并发用户EPS FallBack到4G语音挂断后不能快速返5G.docxVIP

  • 90
  • 0
  • 约1.8万字
  • 约 15页
  • 2021-09-12 发布于安徽
  • 举报

5G优化案例:数据和语音并发用户EPS FallBack到4G语音挂断后不能快速返5G.docx

数据和语音并发用户 EPS FallBack 到 4G 语音挂断后不能快速返 5G 案例 【摘?要】5G 网络数据和语音并发时进行 EPS FallBack,语音挂断后不能快速返回 5G 【关键字】数据和语音并发、EPS FallBack、快速返回 一、问题描述 在 5G 网络数据业务和语音业务并发场景,用户拨打语音电话 EPS FallBack 回到 4G,电话挂断后,约 14s 返回 5G。 从 log 看,语音挂断后,终端侧还保持有数据业务,在停止数据业务后,网络 才给终端配置异系统(NR)的 B1 测量事件,才切换回 5G。 具体对应的测试用例如下: 编号 测试规范名称 测试用例 1 中国电信 5G 终端测试方法- IOT 现网分册 TC-MF_IOTFT-02012 [必选] 快速返回 5G 网络 验证(测试集选择码:110111) 二、Fast Return 技术原理 当 NR 终端语音回落到 4G,语音业务结束后,有数据业务或者无数据业务,都要快速返回 5G,即为 Fast return。 具体过程如下: Figure 1: EPS to 5GS handover using N26 interface, preparation phase This procedure applies to Fast return for EPS Fallback (TS?23.501), 1 . Step 1 to NR event B1 Measurement configuration and measurement report. Event B1 (Inter RAT neighbour becomes better than threshold) (TS 38.331) The UE shall: 1 for UTRA and CDMA2000, only trigger the event for cells included in the corresponding measurement object; 1 consider the entering condition for this event to be satisfied when condition B1-1, as specified below, is fulfilled; 1 consider the leaving condition for this event to be satisfied when condition B1-2, as specified below, is fulfilled; Inequality B1-1 (Entering condition) Mn+Ofn?HysThresh Inequality B1-2 (Leaving condition) Mn+Ofn+ Hys∈Thresh The variables in the formula are defined as follows: Mn is the measurement result of the inter-RAT neighbour cell, not taking into account any offsets. For CDMA 2000 measurement result, pilotStrength is divided by -2. Ofn is the frequency specific offset of the frequency of the inter-RAT neighbour cell (i.e. offsetFreq as defined within the measObject corresponding to the frequency of the neighbour inter-RAT cell). Hys is the hysteresis parameter for this event (i.e. hysteresis as defined within reportConfigInterRAT for this event). Thresh is the threshold parameter for this event (i.e. b1-Threshold as defined within reportConfigInterRAT for this event). For CDMA2000, b1-Threshold is divided by -2. Mn is expressed in dBm or in dB, depending on the measurement quanti

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档