产品安规设计之要求与测试教材.pptxVIP

產品安規設計 之 要求與測試;General Principles;Switch Power Supply AC Power Inlet AC Power Switch Fuse ( for both of AC and TNV circuit ) DC Fan PCB Plastic ;Safety Parts;Power Cord Power Adaptor Laser Transceiver Conducive Coating Transformer (TNV) 以上所有之安規零件均需通過安規單位之認證. 須通過哪些安規單位之認證 ? 只要產品本身有通過哪些安規單位之驗證, 則其使 用之安規零件亦須通過哪些安規單位之驗證. ;標示;如設備須連接至多相電力系統, 則須另外標示相數, 如 2φ, 3φ等 額定電流值, 單位為 mA or A 製造商名稱或 Trademark Model name . ;如設備為 Class II , 則須加入 “ “的符號 P.S. 可以有額外的標示, 但先決條件是不可造成誤導或混淆;標示;標示;鋰電池 : 設備內若有可更換的鋰電池, 則鋰電池旁須有下述 或類似的警告標示. Danger of explosion if battery is incorrectly replace. Replace only with the same or equivalent type recommended by manufacturer. Dispose of used batteries according to the manufacturer’s instruction. 要求 : (1). 標示不可置於可取下之物品上 (2). 要求之標示, 須清晰可辨, 且為恆久的標示.;安規主要設計要求;安規主要設計要求;; ;安規主要設計要求;依 Input Power Rating +6%, -10% 來作為測試的範圍. 100-240V, 50-60Hz, 1A = 測試點為 90V/ 50Hz 及 60Hz 254V/ 50Hz 及 60Hz If the rated voltage is 230V single phase or 400V three phase the tolerance shall not be less than +10% and -10% 判定 : not exceed the rated current by more than 10% under normal load.;;適用情形 : 有開孔之外殼 A. 上蓋之開孔 i) not exceed 5mm in any dimension. ii) not exceed 1mm in width regardless of length iii) be so constructed that direct, vertical entry of a falling object is prevented from reaching such bare parts by means of trap or restriction.(如下圖例) ;B. 側邊之開孔 a. not exceed 5mm in any dimension. b. not exceed 1mm in width regardless of length. c. 開孔位置適當, 並在其 5° 角範圍內, 無具危險電 壓零件存在. 投影 5°角範圍的定??? (如下頁附圖);以類似百葉窗的開孔方式, 使其5°角的投影範圍內無危險電壓零件;C. 底部之開孔;外殼開孔, 固然千變萬化, 但是以 test ping 測試時不可碰觸到具危險電壓的裸露零件為原則.;Test Finger;2. Accessibility Test :;2. Accessibility Test :; 3. Energy Hazard Measurement;4. Humidity Test Re