采用绝对节点坐标法对同步带传动系统进行弹性动力学分析外文文献翻译、中英文翻译、外文翻译.doc

英文原文 Nonlinear Dyn DOI:10.1007/s11071-015-2076-3 ORIGINAL PAPER Elastic dynamic analysis of synchronous belt drive system using absolute nodal coordinate formulation Abstract When synchronous belts are engaging with sprockets, they have complicated dynamic behaviors because of their complex composition. The inertial and damping forces of synchronous belt cannot be neglected when the belt is in a state of high acceleration or high-speed transmission, and these factors considerably influence the selection of belt type and the overall design of the system. The pretensioning force also significantly influences the stress state and fatigue life of synchronous belts, so a pretensioning analysis should be carried out before the elastic dynamic analysis. Our goalinthisworkistostudythepreciseinfluenceofiner- tial and damping forces on the dynamic performance of synchronous belts under high acceleration or high speed. Toward this end, the pretensioning and elastic dynamic analysis of a synchronous belt drive system using two-dimensional beam elements without shear deformation based on the absolute nodal coordinate are studied in this paper. To verify the results of the elastic dynamic analysis, a rigid–flexible coupling dynamic simulation of synchronous belt drive system with the dynamic software RecurDyn is also carried out. The results are presented in the form of stress curves for the synchronous belt. Keywords： Synchronous belt drive system ；· Beam element ；· Elastic dynamic analysis ；· Absolute nodal coordinate ；· Rigid–flexible coupling dynamic simulation 1Introduction 同步带链轮 同步带链轮 Fig. 1 Typical synchronous belt drive Figure 1 shows a typical synchronous belt drive for power-transmission equipment involving rotating mechanical elements. A synchronous belt commonly consists of tensile cords, a rubber compound that forms the teeth bulk and the backing of the belt, and facing fabric covering the belt face and teeth face. The tensile cords bear the external loads, and