集团人员定岗定编方案.docVIP

集团人员定岗定编方案 定岗定编方案 董事会:谭X 肖X永 赵X文 何X全 董事长:谭X 执行董事:陈X 秘书处(人员定编4人) 秘书长(1人):范X飞 秘 书(3人):急招(1人) 待招(2人) 监察部(人员定编3人) 总 监(1人):杨X 监察员(2人):待招 总经理:卢X光 常务副总经理 陈X 何X良 副总经理:马X春 财务中心(人员定编13人) 财务总监(1人):杨X平 财务部经理(1人):贾X 审计部经理(1人):汤X容 统计部经理(1人):待定 统计员(2人):急招(1人)待招(1人) 资产部经理(1人):李X根 会计主管(1人):宁X平 会计人员(3人):急招(1人)待招(2人) 出纳员(2人):急招(1人)待招(1人) 人事行政中心(人员定编14人) 人事行政总监(1人):待定 人事部经理(1人):孟X男 人事专员(4人):待招 行政部经理(1人):石X 行政人员(3人):何X、待招(2人) manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set up indicators to monitor over quantity. To prevent the